Widget Labels

[The RV8 Pilot]

Is there a way to remove/change a widget label? I have been manipulating the user_config file to make better use of the widgets and noticed the RPM has two RPM/RPM labels at the bottom. I want to remove one RPM as well as remove BATT from BATT Volts. Any ideas?

Thanks Michael

 

[DBRV10]

Yes, go into the sensor setup and where it says show sensor units, select NO

 

[The RV8 Pilot]

TY I’ll go in and try that out!

 

[The RV8 Pilot]

I found that at the end of each pin description the "show units" was set at = 1, I changed it to 0 and that removed the label.

 

[Dynon]

While you can toggle it manually in the sensor file, that's also something that can be toggled in the on-screen user interface too.

 

[The RV8 Pilot]

I just realized that was possible after reading your reply.
Thank you!
Michael