Hi!
We have a problem that altitude for transponder (Garmin 328) output from Dynon d-100 – encoder is showing cca 300ft wrong. We noticed this because controller was starting to say that we should check our altitude. We cross checked also with other aircraft
We did pitostatic on the aircraft last week and have also cross checked it with altimeter and pitot static tester, so we know now 100% that it shows wrong.
In the manual it says, that you can not “trim or adjust” altitude that Dynon outputs to transponder. So is there any way to solve this problem? Thanks for answer. Iztok, AIRNET
We have a problem that altitude for transponder (Garmin 328) output from Dynon d-100 – encoder is showing cca 300ft wrong. We noticed this because controller was starting to say that we should check our altitude. We cross checked also with other aircraft
We did pitostatic on the aircraft last week and have also cross checked it with altimeter and pitot static tester, so we know now 100% that it shows wrong.
In the manual it says, that you can not “trim or adjust” altitude that Dynon outputs to transponder. So is there any way to solve this problem? Thanks for answer. Iztok, AIRNET