Latest activity

Pull the user data from the Skyview and look at the data in Excel. One of the columns of that data is for Autopilot Disconnect, look for...

I would like to bring to your attention an issue I experienced with the Dynon Pitot Heater Controller, P/N: 100640-000, installed across...

Read last sentence of post #7 again. 😞

Yes.

I usually do a search for the term, and it shows quickly the table of contents entries and then, of course, more, but the TOC results...

Swatson, where did I imply that the AOA would calibrate itself? Having READ the above emails I am in a quandry. I will give you the...

I have been having a random A/P disconnect problem for several months. Just goes off. The TINY AP color change when it goes off is...

Well, it's not hidden...you just have to do your homework. Presumably, you start with the installation manual, since you have to...

Thank you Raymo for the info. But.....here is the problem: The 500 page installation guide covers the calibration of the indicator with...

@bdog I found it in the Dynon Pilot Guide.

Thank you swatson !! That sentence certainly helps answer the question. Problem is...Where did you find it? And why could I not find...

More progress... The magnetometer and Dynon GPS antenna have been mounted. Wire harnessing in the wings are installed and secured, as...

More progress... The magnetometer and Dynon GPS antenna have been mounted. Wire harnessing in the wings are installed and secured, as...

My bad, I should have asked more, assumed too much 🙄😁 - A/P Panel is an unknown but likely not fitted ? Resistors = not required & not...

Yes i have two breakers, one for each servo. A disconnect resistor? NO. AP panel? I have to check. Thanks for the info, i‘m on it. So...