Latest activity

They’ll work for sure however more $$$ and you have to cut off the connectors on the supplied probes = a lot more work too. I usually go...

Or you could use connectors that are *designed* for thermocouples...

Just spoke to Dynon. They have the two diagnostic logs that I provided and they will be doing analysis on the data.

I had this for the first time on shut down yesterday after a normal short flight.

I know some call us 'coneheads' but a 'mind reader' ?? NO.🤣

"That's NOT them ......." Hi Jake, Did I really have to say "for illustration purposes only"? 😈

That's NOT them & 'blue' is usually for ~18-16 awg ? Thermocouple wiring that Dynon uses are in the 22-24awg ? range & need the 'red'...

https://forum.flydynon.com/threads/system-event-3.14803/

You have covered the first requirement - proper crimping tool. What of the second - quality connecters? Good quality connectors will...

Yesterday the three SV-HDX1100 in my RV-10 rebooted during takeoff. Each time during takeoff and full throttle. On Sunday when I...

Never mind, Dynon Support says it can’t be done.

Do not use these, they are the worst. They are called an OLC-2 connector, and EI have been supplying them for years. I can't tell you...

Just saw the announcement that Dynon has acquired Trig. Perhaps now Dynon will finally offer some version of the Trig TX56 or TX57 NAV...

Just saw the announcement that Dynon has acquired Trig. Perhaps now Dynon will finally offer some version of the Trig TX56 or TX57 NAV...