Latest activity

I recently bought an airplane with Avidyne 550 and 440 with the Dynon Skyview and Autopilot. I am struggling with ILS approaches. I fly...

First of, how did you determine the radio noise is from the Dynon HDX EFIS? The autopilot panel interface to the HDX is connected...

I think I have it fixed. After answering that I had two feeds fused at 5 amps each, I went back and checked. I realized I had one 5 amp...

Just be careful...it sounds like you fixed it, but maybe didn't really figure out root cause, so the fix might only be temporary. Fly...

That's what matters.

Could be a breaker going bad or a wire in the power circuit frayed to the point that its getting hot. 2 SV-32s pulling 1.3 amps each at...

Just some easy checks: 1. Did you go to setup on the HDX and verify that the servos and AP control head are being recognized on the...

I recently installed a new HDX in an effort to find a radio noise problem. The new HDX did not resolve the noise problem so I...

Hello everyone In my ultralight I have a TRX 1500 connected to the Skyview HDX, since the last update of the Dynon software ADSB signals...

Could be a breaker going bad or a wire in the power circuit frayed to the point that its getting hot. 2 SV-32s pulling 1.3 amps each at...

Sold

I was flying around the DFW area last Wednesday and never got a single In-flight weather product on my Skyview system or my connected...

Thought I would share what I ended up going with this https://www.amazon.com/dp/B0BY2WH7QB?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1. I did...

Been a while since any updates on this thread. Has anybody managed to to upload frequency from Skydemon to Skyview as well as drive...

In cruise in a BE35. The engine sensors' display values on my HDX jump around a lot (> 50 degrees) when the RPM is < 2400. Once I go...