Latest activity

Yes, I thought about wiring a separate circuit to by-pass the a/p panel. Guess I could temporarily use the 15 pin connector to power a...

How DARE you! :D

A while ago, before the SB, I had several customers with issues with the a/p panel. My temp solution to enable them to fly was to make a...

You might try temporarily removing the AP panel from the circuit by simply wiring around it directly to the hat switches, one at a time...

This is a known issue. I have two HDX screens that update perfectly but a friends screen stops every time we update it. I thought there...

At the risk of getting blasted could you just have a look in the installation manual . In the EMS section there are full instructions on...

The wrap is only on the face of the panel, the edges where the panel mounts to the airframe is still bare. I might try taping up all...

The jacks were not removed, they're mounted under the seats with fiber washers as before. The audio wiring harness was not moved or...

New installation. How do I swap my fuel level indicators? The right tank is on the left and vice versa. Thanks, AR

Update: I rebooted the HDX with the thumb drive in the USB. Several messages flashed on the screen followed by the PFD. So I think...

I completed a new HDX installation and am updating the software. My last screen says Firmware Update 100% and it is frozen now for 30...

Yes, that would be prudent, thank you for the suggestion. For now, no immediate or close-by candidates available to test my A/P PANEL in...

Were the headset jacks removed? Do you have shoulder and fiber washers installed on the headset jacks?

Is the vinyl wrap preventing the panel grounding to the airframe? Perhaps the bare aluminium was grounded to the airframe but, now it's...

Quite a few forum threads and articles have at various times addressed ground loops, and their potential to cause noise or other...