Latest activity

I did. As Rhino suggested, I asked Dynon directly and got this answer: I'm going to run some prints with theirs and the EASA/Airbus...

I did. As Rhino suggested, I asked Dynon directly and got this answer: I'm going to run some prints with theirs and the EASA/Airbus...

I did. As Rhino suggested, I asked Dynon directly and got this answer: I'm going to run some prints with theirs and the EASA/Airbus...

I'm curious if you found the answer. I've tried a few font detecting sites (incl the adobe) and there was no exact match, but my PFD...

Hi wiring up the IROXON BT753 to a Dynon Skyview port I'm looking for help with the Dynon end of the configuration when using...

Where's @SV_Classic when you need them?

Where's @SV_Classic when you need them?

Yes, I thought about wiring a separate circuit to by-pass the a/p panel. Guess I could temporarily use the 15 pin connector to power a...

How DARE you! :D

A while ago, before the SB, I had several customers with issues with the a/p panel. My temp solution to enable them to fly was to make a...

You might try temporarily removing the AP panel from the circuit by simply wiring around it directly to the hat switches, one at a time...

This is a known issue. I have two HDX screens that update perfectly but a friends screen stops every time we update it. I thought there...

At the risk of getting blasted could you just have a look in the installation manual . In the EMS section there are full instructions on...

The wrap is only on the face of the panel, the edges where the panel mounts to the airframe is still bare. I might try taping up all...

The jacks were not removed, they're mounted under the seats with fiber washers as before. The audio wiring harness was not moved or...