Latest activity

Just visually. It would be nice if there was a loopback test from the primary network to the secondary network on the DB-9 connector to...

Then you'd just use an unmanaged hub or switch with standard cables, and ditch the crossover. I don't have the diagram for the rest...

I understand the SV-NET-HUB connection - and that is not an issue. However the two existing displays are connected via Ethernet also -...

I'm not sure what you mean by "network hub for ethernet etc." The SV-NET-HUB is serial. You can't combine it with ethernet. Adding a...

Yes.

I have an RV-12 with a Rotax 912 ULS engine. It's my understanding that the HDX has a Totalizer in it. The RV-12 has a fuel return line...

Thanks Jake, I'm confident I'll manage. If lost, I'll come back to you. I ordered a trim relay and it has a pretty straightforward...

I have a diagram on how to do that if you want, it uses the same pin numbers as the 15 pin connector ?

Dynon has a document detailing the wiring of a third HDX display (network hub for ethernet etc) - I have misplaced the one they provided...

How DARE you! :D

I’m setting currently setting up the Bluetooth to run the AP from SkyDemon Any chance you could share the port setup configuration for...

Hi I see from your post that you successfully got the AP working using Bluetooth from SkyDemon I struggling with the Dynon side of the...

Cool... the new windshield has been installed. No more peering out of a milky and crazed one when flying into the sun.

Did you check the pins on the D1000 itself?

Went to fly today and got a CAUTION message for a secondary network fault. Checking the network status page shows the D1000 display has...