Latest activity

Thanks for the reply. Not that I'm aware of, but I can check. Everything on my plane is the stock Van's configuration.

Here's some more data to help understand this issue. I downloaded the Skyview data logs and plotted them on Savvy, and sure enough the...

Your BATT warning light is on, suggesting low battery voltage. Do you have a contact pin on the EMS configured as a battery warning? Do...

Yesterday while flying my RV-12iS my Skyview (v16.7) issued a WARNING with the text BATT CONTACT LOW about 30 minutes into the flight...

I have Infinity stick grips in my airplane and had a similar relay board before I installed my AP panel which now serves that function...

Was that a Dynon-produced cable or owner-built?

Hi Thanks for the info I’ll give it a try when next at the airfield Mark

OK. Yours might be slightly different as will depend on what you already have configured… SERIAL IN DEVICE: Garmin 296. (Others will...

I agree. It's patching in all the other stuff he wants that will be his biggest challenge. I knew what you were getting at. But you...

My point was, with a $40 switch and a couple of ethernet cables, the OP can have what he wants. Seems simple enough.

I had something similar happen with no real solution, but to say you are not alone. My hardware version 1 HDX1100 died so I installed a...

I did. As Rhino suggested, I asked Dynon directly and got this answer: I'm going to run some prints with theirs and the EASA/Airbus...

A crossover cable has pins reversed from a standard ethernet cable, so they are not interchangeable. Dynon uses a crossover cable...

Had this issue with my friends' RV-12. The secondary network cable pinouts were backwards. The white with blue stripe, and the white...

So I don't know crap about having a 3rd display - I only have two. But you already know what you need to do for the SV-NET and for all...