Latest activity

Could be a bad motor. Do you have another servo you could swap it with?

Hello everyone, Unfortunately, the shear screw is not broken!!! However, I did a ground test that could help (experts) find the cause...

Thank you for your reply. We've managed to find the source of a transponder snag that we thought might have been the update but, turns...

It is possible to go backwards in software with the system. The transponder is a bit more difficult to do so, normally that's something...

Well,after returning to plane and applying power to HDX, the next day,it appears that the Txp did load up after all and the Txp Ver 2.15...

Thank you, Jake. I plan to check that this afternoon ...

Maybe the shear screw is broken?

Have you checked the ADAHRS mount security ? ;)

Does this happen gradually, or all of a sudden? Are you using only the ground calibration, or are you doing the in-flight calibration...

Hello everyone, I have been flying for over 10 years with a D10A and an SV32 servo for roll. During installation and testing, I had no...

After a couple of months the little airplane on the screen shows up angled off the direction of travel and the indicated wind direction...

What do you mean by loses it's calibration?

@Blimpguy Hi David, Is it possible to revert an update if a previous version showed the transponder as working properly but the new...

Hi Jeff, If you haven't already, please email us at support@dynon.com. You can put attn: David and it will get to me directly.

I have been successful in calibrating my Skyview compass (both on the ground and in the air) but after a few months it seems to loose...