Latest activity

So here we are 4 years later. Issue had been intermittent over the years and no longer temperature related. Resetting the display cured...

Thanks.

I couldn't get it today. Here is the location of the editor: Installation Manual SETUP > EMS SETUP > SCREEN LAYOUT EDITOR. I'll try...

Dear all, I'm having a hard time with that company, I got my first CO guardian sensor showing from the begin a ppm count from over 900...

I couldn't get it today. Here is the location of the editor: Installation Manual SETUP > EMS SETUP > SCREEN LAYOUT EDITOR. I'll try...

The implication was it will display GPS derived “pseudo-DME” without actual DME equipment and based on the NAV frequency tuned in your...

The GP inputs have an internal bias voltage applied, so you'll always see something with a meter if it's powered on. I think he's...

It looks to me like the question was whether or not the OP needed a DME receiver. Perhaps he or she will clarify.

Understood, however the question was about the “virtual DME” on the Dynon PFD. According to the Dynon manuals, that feature must be...

I don't see too many DME receivers these days. If you have an IFR approved GPS navigator I don't believe you need a DME receiver. AIM...

OK...thanks for that. Mike

No, I have 4 EGT and 2 CHT in one of my airplanes. I'll try to remember to take a picture of it today and maybe see how I set it up.

Thanks. I wonder if it is because I have 4 EGT probes and only 2 CHT sensors (the 2 that Rotax supplies)? Perhaps the number of EGTs...

My guess is that if the radio died while you keyed the mike, the likely culprit is the antenna circuit, no matter what the VSWR is at...

What jnmeade said & further elaborating my post #8 - check the pins at the ends of the coax BNC fittings. The pointy end of the pins...