Latest activity

Don’t think so. Calibration moves controls in correct direction. Of course that doesn’t activate trim, so I’ll check to see how trim is...

The calibration process will fix that - eg when it ask which way the tab moves - there’s the clue 😉 You do not need to reverse the wires...

Your trim is wired backwards.

HDX or PANEL-AP. Whether in expert or basic modes. Calibrated it twice. If I set it to ALT HOLD at the current altitude with current...

Did you see this alternative if a new one is needed...

Thanks for the input. I did install it today using one of the GP Pins and set it to the Dynon OAT sensor as a test and the sensor is...

Pneumatic rivet squeezer with the 2.5 inch yoke and quick change pins and adjustable set holder. No damage,no corrosion. $400

Thanks

104781 is the Kavlico sensor Dynon used to sell. They no longer sell it since they came out with the 105493, but there's nothing wrong...

I'm about ready to install my manifold pressure sensor and expected part # 100434, which has been discontinued. I received part #...

Never mind, I think I found it... On page 12-10 of the Skyview Installation manual (Rev AJ), last two-line paragraph, it says: I'm not...

Thanks for the input. I did install it today using one of the GP Pins and set it to the Dynon OAT sensor as a test and the sensor is...

Then it should be fine with a general purpuse EMS input channel. I have dome similar with a PTC, the hard part might be just finding...

Actually there’s a lot of books, c ya later alligator 🤣 it’s still the English language like u speak, just a little different - well, a...

I was getting ADS-B Partial sometimes here in northern Ohio. It also seems to be reported as ADS-B No Radar. From the user guide: An...