Recent content by Mzwijacz

Sent Pm again. Michael Z.

I forgot all about this... sorry. It seems that since the non-waas gps does not show glide slope, there is no horizontal line on the HSI during boot up test.

PM sent Thx ! MFZ

Marc, I started with one of the AeroElectric designs, but deviated in the classic "Experimental" ethos. The full reasoning we can discuss the next time I see you. Thx. Michael Z.

Problem/Desire: Power Skyview display and supported items from 2 separate batteries. The purpose of which is to power up the Skyview system to input flight plans and have ems ready for engine start. Once engine is started, oil pressure values are immediately available. Starter and second power...

I am also very interested in one. Can be reached at 530 - five four 4 - 77 tree tree. Michael Z.

I have the HSI source set to the 430. It is showing the deviation on the CDI but not the vertical deviation sent from the 430 test screen. Thx, Michael Z.

I have a Skyview 10" classic and Garmin 430 non Waas. During the test screen on the 430, the Skyview HSI displays the CDI offset from center. But, there is no glideslope indication. I've had the 429 wiring tested and confirmed that I didn't fat finger the pin numbers. The 430 just returned from...

Does anyone have the data format for the Dynon ADS-B receiver ? I believe it is an "enhanced" GDL90 format, but cannot find any documentation. I want to send ADS-B data to multiple devices. I'm thinking of connecting an ESP-32 micro controller and writing a program to convert the data to...

Thanks I am just starting taxi testing after condition inspection this weekend. It's been a long road. I'm doing without the lights right now and using the Skyview EMS indications and warnings. I may add the lights connected to micro-controller (Esp32) later.

How do you setup Skyview to send and receive information with an Avare table ? I would like to , Send flight plans created on the tablet to Skyview Recieve Ads-B info (weather and traffic) from Skyview I have added my Wi-Fi adapter to Skyview and configured it; added airplane info and...

Did you ever get this corrected and how ?

I will switch the ground to the switch 😁 and retest. Also just recieved my new micro switches. Will try a quick test with one of them.

Ok this is what I did ..... not sure what fixed it. Connected the old EI head to the FT-60 and confirmed the transducer was working . Depinned 14,15 and 30 from the EMS module and tested pins 14 pwr , 30 grnd for power. With the battery charger on, I go 13+v. Checked the pins for looseness or...

I am testing the canopy wiring and setup before installing. I have a microswitch attached to pin 22. It is sending 12 v to the pin when the switch is open. To the same switch output I have a small warning light, recieving the 12v. The light is grounded seperatly. In the Dynon setup I have pin 22...