Recent content by preid

“have that wired directly into pin 35 (blue wire) for the left side low-voltage input.” Blue which is pin 34 is correct be sure you don’t have 35 configured on gauge. ;)

works beautifully now! nice job putting this together! Thank you!

Great app for creating the checklist, I had a problem with saving however. Everytime I saved the checklist it adds a space that doesn’t show any “item” lines on the bottom right preview screen. I went into .txt and removed spaces that made the item lines viewable again, but if I try saving that...

I had this issue but it showed up to 7psi with the engine off so I cleaned up the connections (no change) Grabbed an ammeter and checked the resistance (connector and ground on sensor). for me it was at 29 resistance than down to 10 when I tapped sensor body lightly with screwdriver. I have a...

Thank you! I seem to definitely have an older version of .sfg. Appreciate you bringing that to my attention and the detailed reply with steps!

interesting i don’t get that option.. wonder what else I am missing.

I tried your steps RV8JD, I dont have any of the adjustments you show. Just the name of the sensor "100434-000"when selected. Maybe a newer firmware change? Im still on 16.1 version with older skyview.

The plane flying straight without AP would tell me the plane is fine and to recalibrate the inflight autopilot. I would do the full autopilot steps, including ground, and inflight calibration to assure that’s not the issue. what firmware are you running?

Have you tried starting the panel using the button1 versus master? In other words without master on can you power on the display using the backup battery? if Yes what happens if you turn on master While the screen is powered solely by BU BATTERY ?Honestly nothing, but asking to assure it...

Post in thread 'Skyview will not boot up with Backup Battery Installed' https://forum.flydynon.com/threads/skyview-will-not-boot-up-with-backup-battery-installed.12223/post-71339 search the forums and there may be more but in summary call Dynon you may have a bad battery interface let us know...

As much as I want this feature, all that was said is “ in development” back in October 2019. Nothing was promised. i can think of a few items in the last 10 years in development that took a few releases to finally get released, than there are others that still have not been released. I believe...

Is this the only time it has happened? has it happened before and not as bad? if first time, wait until it does it a few times, Ive had this happen randomly if its happened before, Ive had that as well over time. Ive replaced the resistor between the plead and mag a couple of times as it works...

Yes, if you lose power during upgrade, it corrupts the OS. Only way to resolve is send the unit back to dynon.(or at least that is the way it was in the past)

No You need the dynon ADSB receiver to see the traffic on displays I certainly wish dynon would allow 3rd party receivers but alas…

I would be quite concerned about the (L) Right Mag causing the engine to almost die.. or do you mean the RPM on the HDX shows no RPM but engine is running normally? The spike is from lack of resistance between the plead and switch, which would cause spikes, not sure why there would be no RPM...