Recent content by Tsperling

As a follow up, today I updated the software to the most recent version and that corrected the problem.

I am experiencing a bizarre problem. Usually following start-up, when I press on the “map” key, then the “direct” button, the screen shows the last dozen or so destinations that I previously went “direct” to. But that does not happen anymore. Instead the screen shows only two destinations—one...

I am experiencing a ADAHRS error, which reads “Disabled: Internal Error - Multiple Sensors” I have a dual classic screen set-up, with only a single ADAHRS, and the error only shows on one of the screens (screen 2). The main screen (screen 1), shows that the ADAHRS is “enabled”. This is the...

I had the precise same problem yesterday, following an in-flight calibration of the AOA indicator on my last flight. In my case, I only have one ADAHRS, and oddly it shows that it "enabled" on one screen (on my screen 1), but "disabled Internal Error: Multiple Sensors" on my second screen. It...

I have dual Dynon Classics, with Winds Aloft and X Wind shown in the bottom left. It almost always shows 99 for both the magnitude of the wind and the cross wind component (see attached picture). Is this a compass calibration issue? Or is something else causing the problem? Thanks in advance.

Another follow-up on this. Just want to thank Dynon and their customer support team. Just top notch. Upon learning of the problem, Dynon promptly provided an RMA, and the repaired the screen and sent it back--all within just 1 week! Super impressive. Thank you Dynon.

As a further update...Dynon just called with an RMA--they are on top of it! Thank you.

Can folks share the process for correcting the RSOD. I have two Dynon Classics installed, and today the pilot screen flickered and then went to the RSOD. Scary. I tried cycling the power with the buttons and then with a manual switch, the screen would not boot and I would only get colored...

Thank you very much Rhino—your response is thoughtful and helpful. Know, I did not configure these settings. I recently purchased the plane, and the user_config file is as the plane was delivered. Just trying to make sense of what is there, before making changes. Unfortunately, I cannot ask the...

I am new to Dynon. But, trying to understand how the system figures out the ranges (and names) for both the MAP and TACH/RPM sensors. When I view the User_Config file, and look within the "ems1 ={", the definitions for MAP and TACH/RPM are confusing: 1) With respect to the MAP definition (and...