172M Panel Upgrade

[Bryant Paulsen]

Cool... the new windshield has been installed.

No more peering out of a milky and crazed one when flying into the sun.

 

[Bryant Paulsen]

Lots of progress to see, for I have been away for a while...

N22230 has a SureFly left magneto installed, so their tachometer signal converter
module was required to be acquired and installed, so that the SkyView could
display the appropriate data during a mag check.

Power should be applied to the entire panel sometime very soon!

 

[airguy]

You're going to enjoy this STC. One issue you should be prepared for is some fishtailing on the AP holding heading, there is a procedure available from Dynon for in-flight autopilot tuning and once we went through that a few times we had it pretty much knocked down.

 

[Bryant Paulsen]

You're going to enjoy this STC. One issue you should be prepared for is some fishtailing on the AP holding heading, there is a procedure available from Dynon for in-flight autopilot tuning and once we went through that a few times we had it pretty much knocked down.

Indeed, I'm looking forward to this STC; it will be wonderful.

Is the in-flight autopilot tuning procedure located in the SkyView HDX System
Airplane Flight Manual Supplement? I have not downloaded it yet.

Thank you for your feedback.

 

[airguy]

Indeed, I'm looking forward to this STC; it will be wonderful.

Is the in-flight autopilot tuning procedure located in the SkyView HDX System
Airplane Flight Manual Supplement? I have not downloaded it yet.

Thank you for your feedback.

 

[Bryant Paulsen]

Awesome. Thank you.

 

[Bryant Paulsen]

More great progress.

 

[Bryant Paulsen]

Firewall forward has been completed.

The lower panel wiring has been completed.

 

[Bryant Paulsen]

Power applied and some initial programming.

Sweet!

 

[Rhino]

It's alive!!!!!!!

 

[benapilot]

This whole thread is super helpful as I‘m designing my own HDX installation…

I see a 5A breaker for “USB” and a 15A for “AUX POWER.” I’m assuming the 15A is for charging ports, but what is the USB breaker powering?

 

[Bryant Paulsen]

This whole thread is super helpful as I‘m designing my own HDX installation…

I see a 5A breaker for “USB” and a 15A for “AUX POWER.” I’m assuming the 15A is for charging ports, but what is the USB breaker powering?

I'm glad that you are enjoying the thread!

The 5 amp circuit breaker protects the 2-port USB component and the 15 amp circuit breaker is for a cigarette lighter outlet.

 

[Bryant Paulsen]

Six Pack Aero is installing the VGs, too!