Search results

Folks, I have been chasing an issue with my Dynon ARINC for some time.  It has worked in the past with no problems.  I have been working with Tim Hass from Approach Stack, who manufactured the cables.  For some reason my ARINC has now gone offline.  Went offline when I installed the radio...

Folks, For quite some time I have been chasing a problem with my ARINC going offline when I turned on the master power.  I even replaced all of my Dynon network cables. Today, I isolated the problem to my Dynon Xponder. When I turn on the master power, it powers up all Dynon products, except...

I reviewed the product guide, and this forum, please forgive me if this has been covered.  Missed it. The Intercom is capable of two Comms - How do you switch between Com 1 and Com 2?

After loading 5.0 software update, ARINC-429 not recognized by the network.  Checked physical connections (Using Approach Stack system). I tested the data out (GNS-430W) on the start up menu (by only hitting enter bottom once) and only the GPS data shows up on the HSI.  The ILS bar no longer...

Folks, Now that it is cold, I have updated my website.  I also included a video of the Skyview while in flight.  It should give you an idea of real capabilities (Hint - I am thrilled!!) http://web.me.com/timfwalsh/Site/Welcome.html If issues, please let me know.  Tim

With the pending release of 3.0.....does this also mean the $500 version of SV-MAP-270 will also be released? Thanks Tim

I was configuring my system once again today.  During the process the ARINC-429 would not be listed as a network device. I had to configure the system on four separate occasions for the system to recognize it. I have the current software.  All connections are solid (power/ground). Even when...

Folks, The settings on the GNS430 are kicking my butt!!  I recently upgraded my panel and cannot get the 430 serial data connection to work.  I have been through this before with an early Dynon software version. I added the Dynon ARINC429, and have the latest Dynon software - 2.6 Assuming I...

Dynon, In anticipation of the release of the Xponder and ARINC-429 next week :-) ....... Tried to look for this, sorry if you answered it somewhere else  :-( Xponder Will it be wired (other than antenna, ground, power) just using using the Network cables?  If so, I assume a Network splitter...

Folks, I have been asked to post my experiences with the Dynon Skyviews, and my Velocity. I have updated my website with observations about the Dynons while in flight. It is not as detailed as I would like, but I will add more details. I hope to add some videos (not from my cell phone :-)  )...

Folks, Now that I am flying the Skviews, I am planning cross country flights.  I really want to configure the system to maximize its capabilities. I have a Gems LS-7 Fuel Level Switch in my sump tank.  It will get triggered once the fuel goes below 6 gallons. I did read the manual, but am...

Folks, I just finished up my “five hours fly off” for my Skyview Velocity panel.  I replaced my entire panel with two Skyview systems.  My CFII, A&P, IA also a FAA ATC wanted me to fly the five hours (this was not mandated by the FSDO).  I wanted to offer my initial observations – WOW!!  My...

Will the 3.0 software update with Moving Map software (SV-MAP-270), and the ARINC-429 all be released at the same time? Thanks  Tim

I have been in/out of the country for the last three months.  I was able to start my engine for the first time today (annual is about complete).  I have a LIO-360. I have my RPM wires hooked up to pins 32/33 (White/Green, White/ Blue).  They are hooked up to the ignition switch through the...

I currently have two Skyviews (version 2.5), each one has the Dynon GPS puck for position.  I also have a GNS-430 hooked up to both via the Approach Stack system.  Each SV “sees” data the same way.  I can tell in the serial setup menu TX and RX are working. One of the SVs reads the GNS-430 data...

OK, I will ask......what is the status of the June release? Did I miss an announcement that it was delayed until X?  Thanks  Tim

Just got back from a lengthy trip.  I was able to very quickly update my SVs version 2.0 - awesome job!! I have two Skyviews, EMS, ADAHRS and I am using the Approach Stack system.  I have the same Dynon GPS hooked up to both systems, both show position - no problem. My question - will the...

I realize that the new software release is not scheduled for another week and a half.  However, if possible, since this is probably the most significant one (Autopilot/HSI) it would be nice to get some preliminary comments from the Beta Testers. Because I am a guy, pictures of the new HSI set...

Dynon, Could you give us a shot of the new map upgrade?  It will be a while before I get to load the update. Thanks  Tim

Dynon, Please forgive the silly question.  The software Skyview releases currently scheduled for 30 March (tomorrow) for the map program - is this the $500 release, or is it just an add on to the existing program? March 30, 2010: Display synchronization, GPS assist (Updated, was February 28...