Search results

Yes, you need to pull a diagnostic file and talk to Support.

We did that with our 172R model a few years ago - you'll love it!

Emphasized portion there - not an ATC clearance, but an operations standard, and apparently only applicable on oceanic tracks. Makes good sense in that scenario I guess, the aircraft is off-radar anyway, more freedom to "operate as appropriate".

Been flying for 25 years, I've never heard that clearance. YMMV.

Same - with my Avidyne 440, it won't get a position in the hangar but my Skyview will.

Agreed on all points. I'm running an Avidyne 440 for IFR, but the Dynon approach plates from Seattle Avionics with georeferenced positioning would allow in a pinch to fly the lateral limits, and just fly step-down altitudes. Wouldn't be pretty but it would work.

This is a slippery slope, providing the ability to shoot an approach without a certified receiver. I get it that people want it, and the device is capable of doing it, but I also see this is ripe for abuse. Barring a ramp check, which is pretty uncommon, nothing stops a pilot from flying...

Caution on the cable splitter for the glideslope - the device you want to use there is actually a DIPLEXER, not a generic splitter. It's a band-pass filter combined with a splitter that increases the signal-to-noise ratio of each output stream for better long-range reception.

Marc - will the G3X supply a glideslope for the vertical navigation? Or do you have to fly step-down altitudes?

You can load the charts from a USB to display on the HDX, with your aircraft geo-referenced over the top of the chart and "fly" the airplane along the charted path by using the autopilot and TRK function, but there is not a way to automatically load the waypoints of an approach into the HDX and...

I did, it was well out of warranty period.

I had one die from water ingress, but no other problems.

I'm wondering if there is a way in the DFG file to note the value of the second fuel sender to negative? So when it subtracts it from the first value you end up summing them?

Marc is right. Given the data you have supplied, the sensors will work just fine. Whether you choose to accept that or not is up to you. There may be other circumstances that may make those sensors unacceptable for one reason or another, but you are clearly unwilling to share that information...

Temporarily backed away? Or permanent? Reference?

Sorry, missed that part. Sitting down and shutting up now.

Whose clutch and servo? Not Dynon's....

Sorry, no. The clutch is magnetic and requires no voltage to operate. The trim amp, on the other hand, very well may - which would lead to an electrical installation problem.

Since Dynon is not the manufacturer of the Ray Allen display, they may not have any details to share. You might want to contact Ray Allen directly. http://www.rayallencompany.com/products/servos.html

From the FM, (Users guide, revision K, bottom of page 8-1) :p "The autopilot’s Level Mode (or Straight and Level Mode) will immediately attempt to reach zero vertical speed and a roll angle of zero. It will not attempt to fly the aircraft to any previous altitude or track and it will not...