Search results

Short answer is no-- won't work. Physically the mounts are the same but that's all.

I have a 32gb stick--- no way it should be close to full.  The datamanager says 6 states selected.  All of the colored indicator balls are green.  What else can I try?? note: I have 24gb free space on my memory stick

I have not deselected any states. Tried deleteing all and redownloading---still no luck. Tried a friends memory stick in my plane and all is well. My memory stick doesn't work in either plane.

Add me to the list of ones not able to access sectionals or IFR Hi & Low charts. All was well until I added a state during an update.

Is the touch screen available on the 7 inch screens?

I agree that the overshoot is controllable with good speed control, but the overshoot cannot be eliminated. The LOC does a nice job of intercepting without the overshoot. I would think the software could be tweaked to allow the same smooth GS intercept. Overshooting, no matter how small, is...

" Likewise, as soon as the HSI GS needle begins to descend, you should see the AP switch from ALT HLD to VNAV mode with another "autopilot mode" annunciation." This is not how my system nor 3 other Skyview systems that I have flown work. While the localizer does capture with needle movement...

I would like to second the request for Tracon freqs. It's very high on my wish list. Thanks Dynon!

I have a 7" Skyview with no EMS. Can I configure so that there is no EMS selection on the menu? I would like to not see a red X if I inadvertantly push the EMS button.

Thank you- It was the servo end I was thinking about. That helps clean things up a bit.

Excuse me if this has been covered, but I have found no mention of this. The install manual (Skyview) has only the twisted pairs going through the db9 connector and the power and disconnect wires being spliced separately.  Is there a reason to not have the power and disconnect wires running...