Search results

I just downloaded the new info last week. No problem, so far. Their system is pretty clumsy, though. Make sure the cache you download the new files to has plenty of space. Also, purge the cache before loading the newest info. If you don't do this, it just won't load and you won't get any...

Don’t think so. Calibration moves controls in correct direction. Of course that doesn’t activate trim, so I’ll check to see how trim is wired.

HDX or PANEL-AP. Whether in expert or basic modes. Calibrated it twice. If I set it to ALT HOLD at the current altitude with current altitude selected it holds for 30 sec then either starts to climb or descend usually with trim up or trim down indications. I can’t trust it. Sometimes the...

According to EarthX, the lead from the battery monitors voltage not temperature. When battery drops to 12.5v it sends a signal that will light an led if connected. I would like to monitor temperature to make sure the battery stays healthy. Below 140F is the goal. Some builders install a blast...

I put an EarthX 900 in my RV14A. I want to monitor temperature near it to make sure temps never exceed max desired. Anybody know how to get this information from a Type K universal thermocouple to my EMS220?

Dynon Tech Support did their magic. Yellow wires from servos thru switch to ground does it. Also, thanks to those above for directing me to proper manual section.

I would like to have an AP disconnect switch on my stick. But, I can't find anything in the literature on how to wire it. Can I just wire it between +12v power and the AP? I'm using a circuit breaker and can always pull the breaker to remove power, but would prefer a button on the stick...

I’m ditching my SW resistive fuel sender in my RV14A and thinking about the Cies unit. Will my Dynon panel recognize it?

Hi, If anybody has configured a Vertical Power PPS and VP-X with a Skyview system, I would be interested in knowing how you configured the output from the PPS to provide ammeter readings and low voltage readings. The PPS instructions have pinouts (see attached) from the PPS going to LEDs for...