Search results

I don't have a menu item within the setup pages for this; the EMS does, but not the EFIS. Should there be a similar item for the EFIS as well?

Here's the schematic from my RV6A installation; I also have an EMS-D10 connected to DSAB. Hope it helps.

Does the D10A still retain the ability to display EMS & fuel pages with the v5.4 firmware? After installing v5.4, pressing and holding button six as called out in the pilots guide does nothing - it toggles to the HSI or EFIS page upon release. Thanks!

Not sure if this goes here or the EFIS forum... I recently finished installation of my EFIS-D10A, EMS-D10, AP74, and two SV32 AP servos.   Everything installed fine - I upgraded the firmware to 5.4 on everything and then configured the various pieces as needed.   So far so good! The issue is...