Search results

After my last Saturday flight, and setting the turn rate limit to 0, everything was going perfect, the Sonex flew level and straight riding over the course line in the Garmin 495 that control in mode NAV the autopilot whit no too much excessive rolling, only the necessary to follow the course...

David 1.- Yes, I have read the read and used the Dynon user guide to install and adjust the autopilot (and understood) 2.- The servo is not slipping. 3.- Installed in a D-180, 5.5 software. 4,- the pushrod is in the outermost hole of the servo arm. 5.- Torque 100% Sensivity 20,Turn rate 3º sec...

Hi every all ! Can Sonex pilots let me know his autopilot adjustments for roll AP-46 servo ? I can´t found a nice straight flight adjustments for it.( its banking too much all the time) Thanks in advance Miguel.

Hi all : After few hours of test flights of my D-180, I have got very low fuel flow readings. The starting K factor was the tag one (29050).To calibrate the FlowScan, I have performed a free fuel flow test on my carb port, measuring the true delivered fuel in 6 minutes versus the indicated...

Re: Error while attempting upgrading to last versi Like Ratman said, I dont think it was a user issue, in this upgrading process, all the steps were going fine. The port COM 4 was recognized, then checked the installed version, then I done a backup and finally start the upgrade 5.0. Every thing...

Hi all, while uploading my D-180 whit the last 5.0.3 version and near aparently to finish the upgrading, a error has ocurred. After trying to upload again (Never has been disconnected the power of the dynon)The laptop can´t connect again with it.The message is: FlightDek-D180 unable to...

Hi all in the forum, and sorry for my english. I have just installed the pitot lines in my Sonex-Dinon-180, and when I performed an airtight test in the presure line with a small air filled syringe (the airtight test was OK), I observed that the horizon line of the attitude indictor move piching...