Search results

Thanks!, Do you have the pin locations for those "four" wires?

I know the AP is not yet available, however I have pre-wired for my servos and can't find where they terminate to the SkyView? Do they go to the SV-1000 or EMS module? I understand if it undetermined. I just need to know where they will eventually go.

Do you think this is correct? Black - ground Red - 12v White - D37 input

I am installing my Dynon C-T-V converter. The SkyView installation manual says in Section 9-12 "connect the Capacitive-to-Voltage Converter to the SV-EMS-220 for power as shown in the TABLE below". There is no "table" below? Where does the C-t-V converter get its power? There are 3 wires, I...

I am sorry but I am confused. Section 9-10 of the SkyView installation manual describes connecting the Encoder Serial-to-Gray converter PN 100362-000. I have a GTX 327, I do NOT need the converter? If not, how is my transponder hooked up. The Skyview manual only describes the use of the encoder.

I am currently running wires in my RV9. I am planning 1 10" Skyview (to start). I have a couple of questions that I hope will help me run some wires until I get the Units. 1. Aileron and Elevator Position wires from Ray Allen servos. Do they get wired to the SkyView (Panel) or to a remote...

Where do you recommend the placement for the Adahrs? I have same issue, my strobe power supply is located just aft and RH side of baggage bulkhead (rv9). Can it be located behind the panel? Wing?

Whoops! Saw the answer in another post. Looks like maybe a while for any comm and over a year for Transponder.

I saw your display at AirVenture. The new EFIS looks great! Any idea if the transponder option with be available with the initial release or within a reasonable time frame for me to avoid having to purchase a garmin unit? Same question for Comm?