Search results

Now I have a big red X across my 7 inch display. The 10 inch is fine. It appears that serial port to the Dynon GPS the old one has failed. i will trouble shoot this tomorrow as I have the GPS receivers crossed wired to the units on Serial port 4 and Serial port 5. I will switch the ports to the...

After doing the latest update for the obstacle and nav database everything looked normal intil I tried to engage the autopilot. I did forget to reboot the displays after doing the download. The pitch would not capture the VS or would altitude hold. It would not. allow the vnav function to work...

I have noticed that my Altitde readout is consistently 2 hundred low on the ADSB tracks on FlightAware Verses what I am flying with a current altimeter setting. transponder and altimeter checks are current for IFR. As well as the ADSB Been to two different shops over the last 4 years for those...

Why can we not engage the VNAV on a segment leg of a GPS approach. It will not engage until on the final approach. Example the NOPT transition leg is 4400 from the IAF to the FAP your at 8000 decending why when established on an inbound leg of the approach can you not engage the VNAV so the...

I just installed a SV250-2020 in conjunction with an already approved IFR ADS-B installation Utilizing a GTN 650 I did this incase there was a failure of the Garmin unit I would not have a back up. I realize that the dynon only would be a VFR backup but would still provide ADS-b out. My...

I have installed the new ADS-B 472 and have several questions. One the targets seem to disappear. So what are the parameters for the ADS-B to display traffic. On downwind. with another RV on the runway showing up on the foreflight with his ADS-B. I do not see Him? 15 miles from the...

What are the limitation on utilizing the USB WIFI Such as. Am I still able to use Seattle Avionics Charts? If I am utilizing a 3rd party GPS like Garmin will it still work programing the flight plans back and forth or will the flight plan have to be changed in the Garmin unit. If it is changed...

I have dual Dynon SkyView with the ADS-B, I also run an IPAD with a Stratus 2. On a couple of recent trips from Atlanta to Columbus, Ohio I have been told of traffic that shows up on the stratus but not on the Dynon display even though it states the we are in the Full mode on the ADS-B Other...

Dynon, Although it has happen a couple times when flying and again today I would like to see what you think While flying at a constant altitude doing about 185 TAS all the sudden the airspeed is flu coating from about 150 to the 185 and changing speeds very rapidly like every nano second. And...

Since Most maintenance is done on Tach time. I find that if I set the tack Cruise RPM setting at lets say 1000 rpm... then the tack time is way up there pass the Hobbs time by about double. .. If I set it near 2000 rpm is is lower than the Hobbs but still faster than a clock flight time...

While I understand that heated Pitot tube is going a Technical Service bulletin.. I have not had any problems.. but would like some help setting it up on the Skyview. I have wired the probe back in October as shown on the wiring to get the Pitot tube to work on the Skyview display. I would...

The predicator line that shows up in blue showing when you will hit an altitude climbing or descending is really nice. It is exactly what our Collins Pro Line has in the Hawker I fly except this one is blue so it can be seen.... I wish you could make it bigger.... but regardless. It is a nice...

How about a VOR/ILS Nav receiver remote that can be accessed by the SkyView Package. Smilin' Jack

I have a dual dynon setup with a 10 inch display and a 7 inch display, the EMS 220 and 470 ADS-b. The only issue I have is when I key the mic for my MGL V6 is that the tapes for CHT and EGT all increase. And then return back to normal after the transmission is over,  if I am in the lean mode on...

What buttons do I push to download the CHT and EGT values as shown on the Dynon Skyview EMS page. Do I just take a photo of it. I would like to be able to recall the readout for a time period such as 30 minutes. Can you help. Can I view these? Smilin' Jack

I have dual SkyViews and the 261 xponder,  indications are that the transponder is working but ATC can not see me.  They could see no aircraft. At an altitude well above what they. Normally can see.I did my first flight of my RV 7yesterday so I will trouble shoot it and see what I can find,  I...

I just finished installing the ADS-B and the Skyview display states partial under the ADS-b. under the system setup serial port it states no signal but are receiving a few bits. The ADS-B box is blinking rapidly.. I believe tha t all is working well with the aircraft on the ground and will...

I just applied power to the Skyviews yesterday and it could not find the EMS or the Transponder. I checked the power to the transponder and it was fine and the EMS is just connected to the Hub. On the Transponder, I did serial runs to both skyviews. The wiring of the transponder is just a...

Where have you folks mounted an ADAHRS unit in a RV 7 Thanks Smilin Jack

I have installed the SV32 in my wing and now the questions concerns the limiting bracket. In the directions there is no picture as to the orientation of the bracket. Anyone have a picture of the restrictor bracket installed on the servo? If not for Dynon, how does the bracket mount. I can...