Search results

I updated to 10.0 several days ago and also have noticed that the airspace altitudes are not displayed on the map. I checked the map setting for AIRSPACE ALTITUDE and it is set to ON. If I pan the pointer into the airspace it will show up, but it used to be displayed on the base map. Is there...

Thanks, will do.

The US Basemaps are still loaded. It just added the europe basemaps. Is there a way to delete the europe basemap?

Today I downloaded and installed the quick update for 7.0.1., however, I noticed after I had installed it that it was the EU update instead of the US version. It appears to operate OK (I see that I now have the europe map database) but I wonder if there are differences that I haven't noticed...

I rechecked the naming and mapping of the RPM and Oil Pressure sensors and both are set to default names and are operating normally, as is everything else, except screenshot and Fuel Tank Reminder. Am I the only one experiencing the Fuel Tank Reminder inop? What activates the timer? Since it can...

I have Dynon's fuel flow sensor and all the fuel flow data is working, including the "fuel used" which resets with engine start. Also, the engine run timer that uses engine start (oil pressure I believe) works fine. Nothing different with naming, probably used default names, but will recheck today.

After loading V7.0 everything seemed OK (except known bug involving screenshot). Last couple of days flying experimenting with fuel tank reminder. First flight set at 5 gal.  No message generated after 12 gal burned. Next flight I set it to 20 min.  No messages or audio alert for fuel reminder...

When I enter a waypoint by "Direct To" or entry into FPL, the Map screen displays a magenta line from my position to the waypoint and the "Navigate" button is highlighted. The flight plan page shows the sideways looping arrow indicating I am navigating to the waypoint. Here's the catch, on the...

Thanks for the reply. I will continue to monitor.

I love my new Skyview system. I have about 8 hours using the system in my just completed RV-7 without a hitch from either the plane or SV. However, this morning about 1/2 hour into the flight (during cruise) my hobbs /tach/trip run/flt trip timers stopped running, and the hobbs and tach timers...

My problem appears to be only with the oil temp widget, only on the 50% EMS screen. The problem first appeared when I moved the widget. A gray image of the widget remained in the old location with a red X overlaid. The widget in the new location seems normal. I tried removing  the widget, but it...

I am wiring my recently purchased Kavlico EMS harness and notice that the instructions for connecting the tach sensor wires to the p-leads call for a 30 k ohm resistor that is supposedly "included". My harness kit did not include the resistors. Were they supposed to be in that kit, or come with...

Thanks, I called tech support and they are sending me a replacement.

I have a new IO 360 M1B from Van's (delivered in March). I purchased the Dynon Skyview EMS harness and sensor kit which included the oil temp sensor (part no 100409-001) which has the 5/8" threads. The sensor threads are too small, and just drop into the hole on the oil temp port. Any ideas? Do...

I have read the read the installation manual regarding the transponder hookup and note that the power is to be supplied by a dedicated circuit protected with a 3 or 5 amp breaker. Do I need to install a switch for power on/off to the transponder or is it controlled from the EFIS display. I...