Search results

Hi Dynon, I live in Australia we only have 1090 MHz adsb and I am interested in installing adsb in only on my skyview. I also have a Garmin 330 transponder. can you sugest the most economical system I can install to achieve this as all I want is to have traffic. Thanks

RE. No altitude readout I have installed V6 and have lost altitude readout on my GTX330. do I have to alter the serial port and if so to what settings, all I am getting now is transponder fail on the messages

yes all Dynon supplied harness and cableing factory installed in CTLS

I have dual 10 inch skyview screens. When I turn No 2 on I recieve "servo fail warning and Roll err and Pitch err". As I turn on No 1 all warnings revert to normal and the autopilot functions normally. Any ideas Thanks

Thanks for all your help. I have a CTLS with factory installed dual SV's and was unable to receive a strong audio signal from my PS3000 intercom. Unkown to me I discovered a trimming 1 Ohm resistor had been installed between the SV's and the intercom.With this negated the audio is operating at a...

Re your reply I have checked the wiring and found the following, No 1 SV pins 13 and 31 go to pin 17 on the PS3000 and No2 SV pins 13 and 31 go to pin 4 on the PS3000. They both go through a trimming resister PT10LN1kOhm. Does this sound correct to you.

Is there a way to increase the audio volume. I have the audio in the SV set at 100% and it feeds into a PS PM3000 intercom but it is very weak The vol control on the PM3000 has no effect on the SV audio .Any suggestions Thanks

My audio output is intermittent, with the AOA warning is perfect on the first activation then fails to work on the next circut. any ideas why this is so.