Search results

  1. V

    System Event 5

    Update: I have since located he reporting form, completed and submitted
  2. V

    System Event 5

    On first boot up of SV D1000 I received a System Event 5 message. Have upgraded to latest software release and System Event 5 still present. Also notice that system will not reboot if only a short time (< 1 minute) since powering down. Boots up ok if left for 10 minutes plus. Please advise...
  3. V

    EMS -220 Type A Contacts

    Could I install a resistor in series to drop the voltage as a safety measure? If so what value should the resistor be?
  4. V

    EMS -220 Type A Contacts

    I am unsure what is meant by "Contacts" I assume this means a change of state on the sensor wire. Can a type "A" sensor input accept and drive a widget on a change from 0 volts to 12 volts DC confirming that a device ie fuel pump is switched on?
  5. V

    Kavlico Fuel Pressure Sensor 101690

    I have 3 fuel tanks and need the 3 available "C" type inputs for the Princeton fuel senders. The recommended input for the Kavlico fuel pressure sensor is pin 8 which is a "C" type. I note however that the "sensor may be connected to any general purpose input pin" What are the issues here...
Top