Search results

And yes the Dynon pushes the frequency over, it’s much easier to enter frequencies using the Dynon.

I installed TT21 and TY91 last year in conjunction with my HDX. Connecting the TY91 was easy, it’s all in the installation manual. Refer also to the TY91 installation manual. I found I couldn’t connect the TT21 as it had no serial output/input pins.

Hi everyone. My build has HDX with Ap Panel and Ray Allen electric trim. I‘ve wired the signal from the trim to Pin 10 on the EMS 220. However when I attempt To map this I hit a roadblock. After setting the function as “sensor”, and picking ah ohm setting, I only get a fixed choice in the...

Thanks Steve. Exactly what I wasn’t hoping to hear. I’m in New Zealand can’t even begin to imagine the logistical and cost of doing that….. Peter

Hi everyone Installing my HDX, As received and installed the backspace and exit buttons on the touchscreen did not work. I’ve installed 16.07, but still can’t get these functions to work. Other touch screen feature function OK with the exception of the touch test, when I try that I get...

Oooops found the thread explaining these wires have been deleted from later harnesses shoulda done more research…. 🙄

Gidday everyone. Working through my installation. Looking at pages 24-8 & 9 of the manual, specifically Table 123 and Figure 251. I don’t seem to have wires 16, 17, 18, and 19 on my harness. (Given as red, black, white and green respectively) Figure 251 shows these wires for USB flash...

Hello everyone. About to install my Kavlico pressure transducer for a Rotax 912 ULS. I note than the manual just says not to install on the engine. Forgetting about the “logistics” of putting it either side of the firewall any pros/cons on putting it either side? Thanks Peter

Hi there everyone. I‘m installing Skyview HDX system on a Rotax 912 ULS. I have the EMS220 and the Rotax kit. The kit contains wiring and two probes. If I want to install probes on the other two cylinders should I just buy two more probes and wire them to the appropriate pins on the plug...

Hey thanks so much, I’m sure we’ll have more questions as we get into it. FWIW when I narrowed the avionics choice down to Dynon/Garmin/MGL this forum and Dynon’s involvement in it was a big factor in going with Dynon. Peter

Hi Everyone. I‘m building/assembling an ICP Savannah down in New Zealand, similar I guess to a Zenith 750 STOL, installing a Dynon Skyview system with autopilot. Luckily I’m getting a fair bit of help in this area because I know next to nothing about wiring and avionics. I‘m installing the...

Great thanks for that I thought that would be the case but this is all new to me. I’m sure I’ll have more questions as I work through my installation… Peter

Hello everyone. Will it cause a problem installing my remote magnetometer in proximity (16 inches) of a com aerial? Thanks Peter