172M Panel Upgrade

Bryant Paulsen

New Member
Joined
Feb 19, 2025
Messages
4
Location
Lynden, WA
It was an exciting day to say the least... I delivered my 172M to the folks at Six Pack Aero at the Bellingham International Airport.

The original instrument panel will be removed and the Six Pack Aero's Legacy Xl Stationary Panel assembly will be installed!

The vacuum and electric gyros were growling. Both nav/com radios failed several months ago. The ADF pooped out in November.

Flying has been a challenge with one hand-held radio.

After the Legacy Xl Stationary Panel assembly has been riveted in place, a large array of quality Dynon components will be installed.
  • 10" SkyView HDX​
  • Mode S transponder​
  • D30 EFIS​
  • Avidyne IFD 440​
  • An auto pilot​
  • All new antennas​
  • Pre-wiring for the co-pilot 7" display​
  • Vertical Control Panels for the auto pilot and Comm radio​
  • Numerous engine sensors (Finally, a Carb Air Temp sensor!)​
  • CHT and EGT sensors for all four cylinders​
  • Primary ADAHRS module with OAT​
  • Lots more Dynon components that will take me a while to figure out their functions
  • New LED nav lights, strobes, and tail beacon, too
I plan on taking a lot of pictures and posting them, so stay tuned!
 

Attachments

  • N22230 Instrument Panel Project 1.jpg
    N22230 Instrument Panel Project 1.jpg
    2.4 MB · Views: 13
  • N22230 Instrument Panel Project 2.jpg
    N22230 Instrument Panel Project 2.jpg
    2.1 MB · Views: 13
  • N22230 Instrument Panel Project 3.jpg
    N22230 Instrument Panel Project 3.jpg
    2.2 MB · Views: 13
  • N22230 Instrument Panel Project 4.jpg
    N22230 Instrument Panel Project 4.jpg
    2 MB · Views: 12
  • N22230 Instrument Panel Project 5.jpg
    N22230 Instrument Panel Project 5.jpg
    2.5 MB · Views: 13

Bryant Paulsen

New Member
Joined
Feb 19, 2025
Messages
4
Location
Lynden, WA
Here's the drawing from Six Pack Aero for the layout of the new instrument panel.

The entire lower region of the panel will be upgraded, too.
  • New Push/Pull circuit breakers for all circuits
  • New ignition switch assembly (No more compliance with the AD. Yay!)
  • All new engine and environment control cables
The control yoke universal joints will be replaced with new ones, too.

Awesome!
 

Attachments

  • N22230 Panel Layout Drawing.pdf
    397.6 KB · Views: 13
Top