296/495

Letpmar

New Member
Joined
Jun 27, 2007
Messages
56
We have a D100 that works well with my Garmin 296 and shows the course on the HSI but when we tried with a 495/6 the menu seems to be different and we could not get it to talk to the HSI it only seems to have 1 serial port where the 295 shows 2 of which we seem to be using port 2 How should we set the 495 menu to let it talk to the HSI

Thanks

Pete
 

Mel

New Member
Joined
May 10, 2005
Messages
32
I have a D10A. But when I changed from a 296 to a 495, I didn't change a thing and it works fine.
 

dynonsupport

Dynon Technical Support
Staff member
Joined
Mar 23, 2005
Messages
13,226
The 296 did have 2 serial ports, but the newer models do not (they use it internally for weather).

If your 296 was wired to use serial 2, you're going to need to re-wire it to use serial 1 on a newer unit. If you already used serial 1, it should be plug-and-play.
 

wv4i

New Member
Joined
May 24, 2009
Messages
11
I presently have a GPS 296 output driving a NavAid A/P (roll only). I would like to use the second GPS 296 output to send GPS info direct to D10A. Would you anticipate any connectivity or other problem(s) with this approach? Thanks.
 

jakej

Well-Known Member
Joined
Oct 10, 2007
Messages
2,121
Location
Adelaide, Australia
No problems at all - if you want redundancy use a DPDT switch to give gps input from either unit to the Dynon and A/P.

Jake J
 

dynonsupport

Dynon Technical Support
Staff member
Joined
Mar 23, 2005
Messages
13,226
You can use the second output from the 296, or you can just spilt the cable going to the navaid. Either system should work fine.

Jake, there's only one GPS in the system. The 296 has two serial outs. No need or advantage in installing a switch.
 

DBRV10

Active Member
Joined
Jun 15, 2008
Messages
926
Location
Brisbane, Qld. Australia
Only 2 x GPS..........That is never enough!!

My SOPS require two in the panel, one in the nav bag, one in the EPIRB and if possible one in your PC ;D
 
Top