N125YX
New Member
Skyview, with Princeton fuel sender. I have one 16 gal tank (Waiex). when I attempted to calibrate the device the table said 3.2 volts on every add cycle, but i elected to use it. I put full when the tank was full, and the calibration failed of course, but now it shows no reading.
* I did see the widget show a reading up and down the scale and then go to zero once.
* Now when I turn on the system the reminder comes up, and it will show 59.5 gal added (no way). If I try to zero out the added it zeros out the 16 in the full column.
* Also I see no fuel flow when the engine is running.
* Sensor hooked to pin 20 (Jab 3300 engine)
Where do I start?
* I did see the widget show a reading up and down the scale and then go to zero once.
* Now when I turn on the system the reminder comes up, and it will show 59.5 gal added (no way). If I try to zero out the added it zeros out the 16 in the full column.
* Also I see no fuel flow when the engine is running.
* Sensor hooked to pin 20 (Jab 3300 engine)
Where do I start?