ForeFlight not talking to SkyView

[N82JN]

Recently my iPad/ForeFlight has stopped talking to my SkyView Classic rendering unable to upload/download flight plans.
I have the WiFi module installed on the SkyView and the iPad does recognize and receive the signal - so I know that SkyView is broadcasting the wifi signal.
But when I try to export a flight plan from ForeFlight to Skyview, Skyview does not recognize of find the Foreflight.

Advice and recommendations are appreciated.

K.N. RV9a

 

[lancair360]

I’ve seen this once or twice where it’s getting GPS and ADS-B from Dynon but the flight plan transfers aren’t available. Restarting the iPad always fixed it for me. Don’t know why it’s happening but I suspect it’s on the iPad / ForeFlight side and not the Dynon side.

 

[N82JN]

I’ve seen this once or twice where it’s getting GPS and ADS-B from Dynon but the flight plan transfers aren’t available. Restarting the iPad always fixed it for me. Don’t know why it’s happening but I suspect it’s on the iPad / ForeFlight side and not the Dynon side.

I tried to close and restart ForeFLight - no luck. I shut down and rebooted the iPad also with not results.

 

[djones]

Check the Local Network switch per the image below. This one is for FlyQ, but Foreflight has this also.

 

[N82JN]

I checked - the local network switch on on.

 

[lancair360]

Well I'm stumped. Did you try simply disconnected from the Dynon Network and reocnnecting? Otherwise I'm out of ideas. Sorry.

 

[kurtfly]

Are you using VPN? It will not do flight plans if you use VPN.

kurt

 

[Dynon101]

I had the same problem... this fixed it

ForeFlight Will Not Connect To Panel

ForeFlight always without any problems connected to the Dynon panel...until now. I go to the iPad settings and turn on the WIFI and tap my Dynon WIFI network and the iPad settings says connected (as usual). I look at ForeFlight screen and it sows my airplane position as usual (my iPad does not...

forum.flydynon.com