ForeFlight not talking to SkyView

N

N82JN

New Member
Joined
Dec 28, 2021
Messages
14
Recently my iPad/ForeFlight has stopped talking to my SkyView Classic rendering unable to upload/download flight plans.
I have the WiFi module installed on the SkyView and the iPad does recognize and receive the signal - so I know that SkyView is broadcasting the wifi signal.
But when I try to export a flight plan from ForeFlight to Skyview, Skyview does not recognize of find the Foreflight.

Advice and recommendations are appreciated.

K.N. RV9a
 
I’ve seen this once or twice where it’s getting GPS and ADS-B from Dynon but the flight plan transfers aren’t available. Restarting the iPad always fixed it for me. Don’t know why it’s happening but I suspect it’s on the iPad / ForeFlight side and not the Dynon side.
 
lancair360 said:
I’ve seen this once or twice where it’s getting GPS and ADS-B from Dynon but the flight plan transfers aren’t available. Restarting the iPad always fixed it for me. Don’t know why it’s happening but I suspect it’s on the iPad / ForeFlight side and not the Dynon side.
Click to expand...
I tried to close and restart ForeFLight - no luck. I shut down and rebooted the iPad also with not results.
 
Check the Local Network switch per the image below. This one is for FlyQ, but Foreflight has this also.
InkedIMG_0001.jpg
 
Well I'm stumped. Did you try simply disconnected from the Dynon Network and reocnnecting? Otherwise I'm out of ideas. Sorry.
 
Are you using VPN? It will not do flight plans if you use VPN.

kurt
 
I had the same problem... this fixed it

ForeFlight Will Not Connect To Panel

ForeFlight always without any problems connected to the Dynon panel...until now. I go to the iPad settings and turn on the WIFI and tap my Dynon WIFI network and the iPad settings says connected (as usual). I look at ForeFlight screen and it sows my airplane position as usual (my iPad does not...
forum.flydynon.com forum.flydynon.com
 
You must log in or register to reply here.
Back
Top