What happens when the screen freezes for hours with the splash screen on the display that says "Do not remove power"? Do you just go ahead and remove power and start over? Does the display quit working? Is the whole Skyview system now irreparably broken?
HDX Upgrade and Network Update Failure
- Thread starter wilkersk
- Start date
andresmith76
I love flying!
- Joined
- Oct 4, 2018
- Messages
- 182
This same scenario has also happened to me. I did what wilersk did and after the reboot, all systems were once again normal and the update completed. I guess sometimes it just hangs. I think the key thing to remember is to wait before rebooting - I waited about 5-10 minutes before performing the reboot.
OK, that problem is fixed. Thanks for the responses.
I have a call in for Tech Support. Sounds like they're busy.
Next problem is that despite following instructions and importing old settings, my VP-X license didn't carry over. Do I have to buy a new license for VP-X?
I have a call in for Tech Support. Sounds like they're busy.
Next problem is that despite following instructions and importing old settings, my VP-X license didn't carry over. Do I have to buy a new license for VP-X?
Last edited:
jakej
Well-Known Member
I’d just contact Dynon Support with the ‘old’ & new display serial numbers & they’ll give you a new code - easy peasy.
airguy
Well-Known Member
Exactly correct, I had to do that once, just call them and they'll give you a code.