Loss of GPS - Power or Signal?

#74430

New Member
Joined
Jun 22, 2020
Messages
29
Hi all,

I have an intermittent issue whereby I lose position data from the GPS-2020. I can't tell if it's a signal data issue or power to the module issue. Maybe the following info will help.

CAUTION:
POSITION SOURCE 1 FAIL
NO ADS-B OUT: GPS LOST

ON MAP:
POSITION UNKNOWN
TRAFFIC FAIL

2 x HDX - Data drops to both at the same time. GPS 2020 remains listed in SERIAL 5 but data transfer is static. There doesn't seem to be any consistent reason for loss. Sometimes it's on the ground, other times in the air after take-off or 45 minutes into flight. Not convinced it's heat related.

GPS Module is mounted on the top of the fuse behind the canopy (RV-7A).

I know I must be a wiring issue but if I can narrow it down to either signal or power that would be helpful. Would the module still display in the system if power is lost?

Cheers,

Dan
Melbourne - Australia
 

Attachments

  • Screenshot 2026-06-14 at 8.39.00 pm.png
    Screenshot 2026-06-14 at 8.39.00 pm.png
    5.3 MB · Views: 31
  • Screenshot 2026-06-14 at 8.39.16 pm.png
    Screenshot 2026-06-14 at 8.39.16 pm.png
    3.9 MB · Views: 33
  • Screenshot 2026-06-14 at 8.39.32 pm.png
    Screenshot 2026-06-14 at 8.39.32 pm.png
    3.4 MB · Views: 34

GT3

New Member
Joined
Nov 9, 2022
Messages
22
I'm experiencing a very similar issue, I checked the GPS Fix Status on my MFD while I was having an issue on the PFD and signal seemed fine.
Have you found anything?
 

Attachments

  • IMG_8260.jpeg
    IMG_8260.jpeg
    811 KB · Views: 3
  • IMG_8259.jpeg
    IMG_8259.jpeg
    811.4 KB · Views: 3

#74430

New Member
Joined
Jun 22, 2020
Messages
29
Yeah I replaced the wiring harness in the avionics bay where the 4 wires split on their way to the 2 x HDX screens... No fix. Ended up being a faulty 4 pin connector tin the tail near the GPS module.
 
Top