My aircraft continually shows up as adsb traffic

[fastfred58]

This is a d1000 skyview new install in a Remos. I did have this problem in my Kitfox after installing the ADSB in but it went away on it's own. Has anyone else had this problem and solved it.

 

[Raymo]

I occasionally see this happen when flying directly over an airport. Sure gets your attention!

 

[fastfred58]

I occasionally see this happen when flying directly over an airport. Sure gets your attention!

This one is on from take off to landing normally. The dangerous part is the traffic sign covers slip indicator ball.

 

[Raymo]

I believe there is a setting in the newer release to avoid this from happening.

 

[fastfred58]

I believe there is a setting in the newer release to avoid this from happening.

Is it automatic or do I have to change something?

 

[Raymo]

Is it automatic or do I have to change something?

Looks like the recent change is automatic. From the 16.0.1 release notes:

Improved: SkyView now filters "ghosts" traffic targets that appear in immediate proximity to the aircraft to prevent false traffic advisories. These "ghosts" usually represent your own aircraft. They are most likely to occur in areas of marginal RADAR coverage.

 

[fastfred58]

Looks like the recent change is automatic. From the 16.0.1 release notes:

Improved: SkyView now filters "ghosts" traffic targets that appear in immediate proximity to the aircraft to prevent false traffic advisories. These "ghosts" usually represent your own aircraft. They are most likely to occur in areas of marginal RADAR coverage.