NO ADS-B OUT: GPS LOST

L

loopfuzz

New Member
Joined
Oct 28, 2008
Messages
12
After installing a 2020 GPS on a sky view classic we are getting this message "NO ADS-B OUT: GPS LOST". GPS is still working on the map.
Also I have update the settings in the dynon config to tell it we are using the 2020 GPS now.

Any ideas? Thanks in advance.
 
How do you know the GPS is still working on the map? Are you out of the hangar with good satellite acquisition?
 
If you have no GPS signal, you will get that message, and have no ADS-B out. (Been there, done that....) I suggest you carefully follow the troubleshooting and testing instructions in the SkyView System Installation Guide - Revision AE, on pages 8-12 through 8-15. It's not that hard, really.
 
My ADS-B and GPS were working fine but not now. I have GPS as the lat/long shows correctly and I can navigate to a point but still get message. Antenna has been replaced once when had same problem.
 
You need to change the GPS data source in the transponder setup menu to the GPS 2020. Go to SETUP > TRANSPONDER SETUP > GPS DATA
 
You must log in or register to reply here.
Back
Top