No GPS Position Source

[Zazoos]

Hey Gang,

Turned on the DYNON HDX for the first time today. Everything seems good except for the "No GPS Position Source."

I opened up the two dsub connectors to verify wiring is correct and the pins are seated and no broken wires. Everything looked great.
Here is what Port 5 is showing with everything looking like it is correctly wired. RX Counter is increasing fairly fast.

I swapped the grey/violet and grey/orange wires and plugged it back in. Here is what Port 5 is showing. Group errors is increase slowly.

Thank you,

Trent

 

[Ricardo Godoy]

Gps receiver 250 or 2020??

 

[GalinHdz]

Does the GPS antenna have a clear unobstructed view of the sky? Not inside a hangar or anything with a roof over it.

 

[Zazoos]

2020 model and I did roll it outside of the hangar.

Thank you,

Trent

 

[Ricardo Godoy]

I had the same problem with a classic and 250 gps. After updating the software, it returned to work.

 

[Ricardo Godoy]

in your settings appears the device in gps 250 ... check if you didn't make the wrong option

 

[DBRV10]

You say you have a SV-GPS-2020 but your settings show you have selected the SV-GPS-250.

Try selecting the correct one.

AND make sure you have the wiring correct, dont go swapping anything.

 

[Zazoos]

Hi Ricardo,

Yes, the problem was it was set to GPS 250. Change to 2020 and it worked great.