Likely you did not have the servos powered on when you installed the newer firmware. To fix this:
1. Turn the SkyView system on - ensure that the servos are receiving power.
2. SETUP MENU > SYSTEM SETUP > SKYVIEW NETWORK SETUP > NETWORK STATUS
The first two items listed should be SV32/SV42/SV52 - what is their status?
If they're not listed at all...
SETUP MENU > SYSTEM SETUP > SKYVIEW NETWORK SETUP > CONFIGURE... > (one more right click) > DETECT (button) >
Likely now they'll be listed, but shown to have the older version of firmware. At this point push the UPDATE button.
After the update completes, push the FINISH then the EXIT buttons.
Your AP should be back to normal now.
I've installed the new SV software and now, while the servos show up in the network status, they show as not installed in the servo calibration page.
I also have issue with one of the EGT probes.
None of this happened while I used SV version 12.