I have sent various support request mails to Dynon.
No respons after 10 days which is unusual compared to earlier contacts with Dynon. Xmas time ?
My problem
In take off the SV1000 classic touch shows intermittend red crosses for adhrs and ems
After some time the units come back on line
First ems returns with red crosses across few sensors which disappear quickly and next the adhrs comes back and re-calibrates. All normal again.
After a while the whole thing repeats and repeats.
During the last flight the gps (sV250)dropped out as well and remains gone.
Back on the ground all back to normal and stable except fo the gps which did not return
I swapped the two SV’s with no result
Also tried one SV on line which gives the same problem.
Ran the network test but no errors.
Feels like an intermittend contact somewhere
I also checked all connectors and shook cable bundles and created strong vibrations but all stable on the ground.
Hope you have a few tips
Jack RV12 Netherlands
No respons after 10 days which is unusual compared to earlier contacts with Dynon. Xmas time ?
My problem
In take off the SV1000 classic touch shows intermittend red crosses for adhrs and ems
After some time the units come back on line
First ems returns with red crosses across few sensors which disappear quickly and next the adhrs comes back and re-calibrates. All normal again.
After a while the whole thing repeats and repeats.
During the last flight the gps (sV250)dropped out as well and remains gone.
Back on the ground all back to normal and stable except fo the gps which did not return
I swapped the two SV’s with no result
Also tried one SV on line which gives the same problem.
Ran the network test but no errors.
Feels like an intermittend contact somewhere
I also checked all connectors and shook cable bundles and created strong vibrations but all stable on the ground.
Hope you have a few tips
Jack RV12 Netherlands