Hello colleagues. Unable to find an answer to my question - I create a new thread.
So. We are building a new aircraft with a Rotax 912ULS engine, D-1000 and D-700 screens. Latest firmware is uploaded. Installed Kavlico 15PSI Fluid Pressure sensor.
Connection and settings should be applied to the EMS menu - according to the instructions on the system and sensor installation (Pin 8).
The problem - it is impossible to change the measuring range in Sensor Setup menu. The default is the maximum - 1.3 bar, and when I try to change this - it lights red and is returned to the original. Changing segments scales and values [ch8203][ch8203]also not working.
What am I doing wrong?
P.S. When I engage fuel pump, value on PFD screen is changing, it means correct connection. But value is not similar to correct from engine manual).
So. We are building a new aircraft with a Rotax 912ULS engine, D-1000 and D-700 screens. Latest firmware is uploaded. Installed Kavlico 15PSI Fluid Pressure sensor.
Connection and settings should be applied to the EMS menu - according to the instructions on the system and sensor installation (Pin 8).
The problem - it is impossible to change the measuring range in Sensor Setup menu. The default is the maximum - 1.3 bar, and when I try to change this - it lights red and is returned to the original. Changing segments scales and values [ch8203][ch8203]also not working.
What am I doing wrong?
P.S. When I engage fuel pump, value on PFD screen is changing, it means correct connection. But value is not similar to correct from engine manual).