We endeavoured today to update to Skyview version i1.1. The right screen updated fine but then came up with a software mismatch error.
When then updating the left screen it locked up at the splash screen. After waiting 20 minutes we tried to power off with the left hand button without success, so powered off the master. The screen shut down immediately (even though back up battery installed).
Powering up again 5 times the right hand screen would boot each time. It was on EMS and would display sensors crossed out.
The left screen would come up with the Splash screen. Each power off it seemed to alternate between running on battery and powering off instantly.
I have the log file (500meg) I can FTP if required and also the various user files.
This is the start of our summer vacation so suggestions appreciated. We have wondered about disconnecting the cable between the two screens to see if that helps?
John O'Hara
When then updating the left screen it locked up at the splash screen. After waiting 20 minutes we tried to power off with the left hand button without success, so powered off the master. The screen shut down immediately (even though back up battery installed).
Powering up again 5 times the right hand screen would boot each time. It was on EMS and would display sensors crossed out.
The left screen would come up with the Splash screen. Each power off it seemed to alternate between running on battery and powering off instantly.
I have the log file (500meg) I can FTP if required and also the various user files.
This is the start of our summer vacation so suggestions appreciated. We have wondered about disconnecting the cable between the two screens to see if that helps?
John O'Hara