sven.jerlhagen
New Member
I cannot get my skyview HDX to show the GS. I have set the VS REQ'D OPTIONS: height=0, dist=0, angle=3. The flightplan below is: ESSL - OSTRA - OL - ESSL. In the screenshot below the GS is seen but the sequencing has messed up and the first leg from ESSL to OSTRA is still active. When I turned final the GS disappeared. On another flight when I manually activated the last leg the GS was still missing. SYNVIS is on and HITS is off.
Another question is why the sequencing failed. The second screenshot shows the actual track in the same flight, I started runway 11, turned left almost to OSTRA, then a big right turn towards OL and landing on runway 29. (Then a go around due to slow traffic ahead of me). Was I not close enough to OSTRA ?
Probably there is something I have missed to set, but I have read the manual several times. It seems only pages 5-45 and 5-46 contains info on this (rev E).
Thanks
Sven
Another question is why the sequencing failed. The second screenshot shows the actual track in the same flight, I started runway 11, turned left almost to OSTRA, then a big right turn towards OL and landing on runway 29. (Then a go around due to slow traffic ahead of me). Was I not close enough to OSTRA ?
Probably there is something I have missed to set, but I have read the manual several times. It seems only pages 5-45 and 5-46 contains info on this (rev E).
Thanks
Sven
