Wiring for Xponder and ARINC-429?

[timfwalsh01]

Dynon,

In anticipation of the release of the Xponder and ARINC-429 next week .......

Tried to look for this, sorry if you answered it somewhere else  :-(

Xponder
Will it be wired (other than antenna, ground, power) just using using the Network cables?  If so, I assume a Network splitter would be required.

ARINC-429

I am assuming a D-sub connector with the wires directly from the avionics would go to one connector, and the outgoing would also go through a splitter to the network?

When are you accepting orders?  I took next week off just to fly (get use to my newly completed Skyview upgrades for long cross country flights).

Thanks  Tim

 

[timfwalsh01]

OK,

I found the wiring diagram for the Xponder  

I could not find the wiring diagram for the ARINC-429 , but will keep looking.  Tim

 

[jbasiago]

Search for New SkyView Products at Oshkosh. There is a post about fifth from the end that has a pinout diagram link. This is what I am using for wiring the SV-ARINC-429 module.

 

[timfwalsh01]

Jack,

Thanks, found it!!

http://www.dynonavionics.com/images/SkyView_ARINC429_d25_male_pin_insertion.PNG

My assumption is that the other connection "out" is to the network - make sense? Tim

 

[jbasiago]

No, the out pins are for transmitting to the attached devices. On the other side of the module, there is a network port that SkyView uses to communicate to the ARINC devices, as I understand it.

 

[dynonsupport]

Note that we now have the full 2.6 manuals live at http://www.dynonavionics.com/docs/support_documentation.html (the web page is incorrectly showing the July revision date right this second, but the links are the new manuals)