There’s a saying “a bad ‘Tradesman’ always blames his tools” - I am guilty of that too, however I’m a fast learner &, since a couple of meltdown episodes (just could not believe it was my fault), I found that working life has been a lot easier after I came to terms with that.
This whole EGT probes/connector episode reminds me of how NOT to react to a problem.
Smart people confess & slap themselves a bit or say “my bad” when they do make a mistake - then move on.
Over the years since ~ 2005 I’ve written several “posts”, mostly on this forum or VAF, based on my experience with mainly the Dynon supplied thermocouple probes & wiring.
Around that time the thermocouple wire, in the supplied looms & probes were a single conductor wire (24 awg ?) which caused all sorts of issues/ connector ‘failures’.
There was a ‘fix’ for that however sometime later the supplied by Dynon probes/loom then had multi strands to better ‘fill’ the connectors enabling more crimping force.
However, yes, there continued to be ‘pushback” by many who said they still had ‘probe’ problems - there is sufficient evidence refuting that IMO.
Using a single jawed crimper &/or using the (dark red insulated) supplied spade connectors are the MAIN cause of reported problems by many.
As an added precaution I always now, & have for the last few years, use a good electrical contact cleaner (pressure pack). Remember we’re measuring millivolts here so contact cleaner is my weapon of choice.
For a few years now I’ve been using the PIDG spade connectors with a double jawed crimper (~ $55) without any ‘issues’.
Also the 2 pin Thermocouple connectors & the OLC type are good too - pick your ‘weapon’ .
Please, please be mindful of your criticism of various manufacturers products - you just may be the culprit

. Jake