EGT & CHT probe failures

Has anyone else experienced excessive EGT/CHT probe failures? We have had our HDX system for just under a year (135 hours) and I’ve already had to replace 2 EGT and CHT probes, then this morning one of the new EGT probes is failing again. They are easy enough to replace, but the failure rate seems excessive. I’m wondering if there is something else I should be looking at.

Failure mode is that the reading jumps all over the place and eventually X’s out, generally within the next flight or two.
Good morning everyone. I wanted to comment on these threads for some time but haven’t had the time. I too had a huge reliability issue with the Dynon EGT probes and was replacing at least one every oil change cycle. After replacing all 4 cylinder probes at least 4 times I said enough. Looking at the aircraft spruce cost of Dynon probes verses JPI probes, it kind of made sense… half the price for half the service (kind of like AT&T). My probes always failed open. Tried to open up the probe but could never determine why, I do know it wasn’t the connector or its crimp. I replaced all 4 with JPI probes and have improved my reliability numbers to what I would expect from a JPI product. Even the Dynon rep at Sun N Fun 2024 suggested I use JPI instead. Who’d a thought…🤔
 
I had two of these garbage Dynon EGT probes fail on me yesterday at the same time. Yes the same time (as I pulled in front of my hangar) and yes I've checked them out with a meter, swapping probes with good ones, etc. They're just bad. And here's the topper, they only have about 2 hours on them. I just flew the plane for the first time on November 10th. What awful quality. I won't buy any Dynon probes in the future. Glad to see that there's another choice with JPI
 
I have used EGT sensors from The Sensor Connection from original installation. They last around 800hrs and even then could probably be cleaned but I just put new ones in. The will also make the leads any length required. I use 24" and just ordered 4 last week. Price was 277 total delivered.
 
We are in the process of stocking a different EGT probe offering from Tempest/Alcor as a premium option for customers. Once we have adequate stock on hand, we'll be able to sell them to those who wish to use a different type from us. The main goal is to improve on the quality and reliability that our customers expect out of these engine probes.
 
I had two of these garbage Dynon EGT probes fail on me yesterday at the same time. Yes the same time (as I pulled in front of my hangar) and yes I've checked them out with a meter, swapping probes with good ones, etc. They're just bad. And here's the topper, they only have about 2 hours on them. I just flew the plane for the first time on November 10th. What awful quality. I won't buy any Dynon probes in the future. Glad to see that there's another choice with JPI
They must be a bad batch. I have 700 hours on mine with no problems.
 
Back
Top