I'm having the same issue. I installed V16.6 a week ago and test flew the airplane and everything was fine ( although I didn't do the AOA calibration for different flap settings yet). Yesterday I calibrated the AOA for 0, 10, 20 and 40 degrees but I didn't do the zero pressure IAS calibration...
I would love to have that on my HDX. When I see converging traffic on my HDX screen I usually then look at my iPad to get the target's speed so I can decide the best course of action to avoid it.
Should the fuel flow widget have a red X through it when the fuel flow sensor is disconnected? I removed my red cube this weekend while doing some troubleshooting for low fuel flow indication and when I powered up the HDX the fuel flow widget didn’t have a red X through it. If I disconnect the...
For those that follow looking for a solution to this problem, the fix that PeterMac provided seems to have worked. The CO value on my Skyview now reads zero when in fresh air as it should. Thanks Peter!
After installing v16 tonight I noticed that when on the VP-X page the cursor knob does not work properly. When I turn the knob, the page jumps to the bottom and then it won't move up or down no matter which way I rotate the knob. I'm able to scroll the VP-X page up and down by touching the...
Thanks Don. I plugged your X1 and X0 numbers into my sensor file but now the CO widget has a red X through it. I'll wait for your updated file to see if that works.
Hello Dynon Support,
I have a question about the CO Guardian sensor definition that's in the most recent EMS software configuration file.
I recently installed a 353D-101 and connected it to SV-EMS-220 D37 P31 following the instructions earlier in this thread. I mapped pin 31 to the CO...