I connected the N16 to my AFS 5600 system not the skyview. However, it will also connect to the skyview. You need the N16 radio as well as either a Vega or Razor control head. If you have the panel room I recommend the Razor because it has a bigger display and is easier to read. The control...
Thanks, that's good to know. I was mostly concerned about them being held in with red loctite. Usually anything installed with that is very difficult to remove without heat. In this case maybe the screws are so small there's not much for the loctite to hold onto.
Thanks and you are correct. I got a reply from Dynon Service and the disk (I called it hub in my OP) is not field replaceable. It would be extremely difficult to remove the remnants of the shear screws from the disk so a return to Dynon would be required.
I have a N16 installed in my aircraft as a backup. I only bought it because it was the least costly way for me to satisfy Transport Canada’s requirement for a second independent nav source. They won’t accept Dynon GPS as an IFR backup. I’ve found that it’s actually a really great radio. It...
I've broken 2 shear screws in my RV-10's roll servo over 4 years and 450ish hours. The original broke a couple years ago and it was chalked up to a weak batch of pins. The second one was one of the newer screws that is supposed to have better fatigue resistance. It broke a couple days ago on...
Is the yaw damper available for the RV-10 now? It's one of the reasons that stuck with Dynon products for this project when I saw that Rob had it in his RV-10 but I haven't seen an announcement of it being ready to purchase.
I've been using the red cube in my Glastar since I installed the Skyview when it was first released. It's never been an issue and is within 1% accuracy in the gravity flow system feeding my 180hp O-360. It has been well tested and proven at extreme angles of attack and full throttle.
I was getting the same error this morning when I tried to set up my system. I had my aircraft identifier set as C_GDWH in aircraft information. I had to change it to CGDWH, no _ in between the C and G. It is now showing online. With the underscore in place the wifi setup was showing a space...
I just got an email back from Dynon Support. Turnaround time for the repair is 10 business days after receipt at the repair shop. With shipping both ways I'm probably looking at 3 to 4 weeks down time. The problem is not annoying enough for me to stop flying for a month to get it fixed. I'm...
I set my EGT and CHT alarms to turn off automatically once the "red" condition is no longer present. I, too, am looking forward to the new EMS module. If you use the leaning function and have to key the radio before you're done you have to start from the beginning.
Mine do the same thing. I've tried shielding the wires, moving my comm coax and added a bonding strap to the EMS module but it didn't make any difference at all.
I read in a previous post that the L-Comm d-sub filters remedy the problem but I have not ordered them. L-Comm wanted over $50 for...