Recent content by TouchTheSky

Alright, I will give it a try.

So after reading it, most likely "reducing ROLL or PITCH SENSITIVITY"?

I im running the latest SkyView version v16.4.4 with all parameters of the AP in DEFAULT mode. In bumpy conditions I sometimes want the AP to be a bit more relaxed and less wiggling. Which parameter should I start changing?

Ah thank you, with the wrong spelling I couldn't certainly find anything here. So few more questions then: Is there a specification available? Is any traffic data included in that stream? Are there any applications already out in the market that make use of this?

Just saw this new item in my SkyView settings, can someone explain what this is about? Either WiFi or Ethernet can be selected ...

I suggest reaching out to the EasyVFR folks, they usually are very supportive. You always have to update two data sets, av_data and ob_data. You have certainly read this document here: http://www.pocketfms.com/Dynon/Checklist.pdf

Your transponder is connected to a serial port, what does the serial page say?

Why don't you ask one of your fellow pilots who have an ADS-B receiver in their airplane or a portable one to perform a test?

Here is my audio setup after upgrading to v16.3.2.

You are not the only one, after updating to v16.3.2 my AOA warning was almost killing me. I made multiple level adjustments and will provide a screenshot as soon as I get to the airport again. It is however not completely resolved.

Not sure why this is not working - I can only recommend to set the TRX serial out to FLARM NMEA and select FLARM TRAFFIC as the HDX serial in device as discussed here: https://forum.flydynon.com/threads/air-traffic-from-air-avionics-serial-interface-setting.13526/. Baudrate to be set accordingly ...

Yes, main audio level is now at 10%, will take a screenshot for the other settings.

Thanks for that, sounds like a solution.

In fact I would be more than happy to install such a potentiometer as the audio level from the Dynon is in any event way to high for my ATR833. Is such potentiometer available as a plug-in adapter so that I don't need to open the D37 connector?

The settings did not change but the audio output was significantly louder (AOA warning during taxi close to damaging my ears) so I tried lowering the level in settings with no real effect. Do I miss something? My HDX is connected to a FUNKE ATR833 where the EXT level is set to "01" ...