Search results

We haven't verified compatibility at this point (but are looking into it). SkyView does stream "standard" ADS-B data over wifi, so it's a possibility. Also, another note is that multiple devices connected to SkyView may not necessarily be able to talk to each other over SkyView's wifi connection.

The official guidance is: "In general, we recommend you mount it at least 6 inches (150mm) below the wing and with the tip of the probe between 2 inches (50mm) and 12 inches (300mm) behind the leading edge of the wing. Typically a pitot probe is mounted about mid-wingspan to minimize the effects...

Can you post a picture of what you're seeing? I'm no sure we're understanding what you're seeing vs expecting to see.

Yes, v16 will be released with the Bonanza A36 update, which is due out soon.

Sorry to not completely clear this up. The control head IS required to use our COM radio. There's no way to control volume remotely otherwise. I suppose one could remotely mount the head off of the instrument panel, as long as you have the ability to reach behind somewhere to adjust volume when...

Just to clarify - if you have two radios connected to SkyView, both will benefit from the connected database. IE, each radio's control panel can pull airports and frequencies. But only the primary radio is visible in the top bar, can be controlled from the COM radio page, and can be sent...

There's some news in our Oshkosh announcements that may help improve things here: https://conta.cc/2UFzpyH

Try continuing to use the the D180 as the master, and see if that helps things.

Small tease - we should have an update that may be helpful for you guys with our Oshkosh news drop next week.

I'd clarify that to say that in some aircraft, acceptable performance can be had with just the ground calibration. But we'd expect that many (most? hard to say without having more robust fleet data) aircraft would benefit from also doing the in-flight cal.

There's been some positive movement here. This updated policy doesn't go into effect until the end of July, and we're looking into the full ramifications. But, it's looking good, and we'll have more to talk about soon...

Try again using the updated links on the website. We think we fixed it.

D189 User guide page 10-4. You may need to do it on the D180 since that timer lives in that unit.

Sorry - I meant - to which Dynon product is each of your Radios and GPSes connected to? And when you had the D180 and D100 connected, which of the, was the DSAB master?

The settings file from your D1000T was probably transported into your HDX, and those "buttons" from the D1000T probably came over that way. I think our support team (contact info in signature) may be able to help you resolve this with configuration file adjustments (or, if you're familiar with...

Frankly, it's to help us understand what might be going on if you call our support team with a calibration-oriented issue. There isn't a way to manually program the fuel calibration on the D180 (there is with SkyView).

Where is everything connected? Your Radios, GPSes, etc? Which unit is the DSAB master?

A revision to this doc is actually in progress now

The winds aloft fix is in for the next software release, which is out sooner than you'd think. We should have some more news to share as Osh rolls around.

So not on the TIMES page, but in the main EMS menu, then TIMES menu, then you should have the TRPRST. It should also show up on the "AUX" page menu (accessed by pressing the not end button under the aux page, button 5 when the aux page is on the right) if there are timers being displayed on the...